SATA to USB 3.0 Adapter Cable for 2.5 and 3.5 Drives

Read any bare SATA drive without opening your PC

Connect a bare drive without the case

The SATA-to-USB cable links a bare 2.5-inch or 3.5-inch drive straight to a USB port. You skip buying an enclosure and skip opening the computer. Set the drive on the desk, plug in, and the files are in reach.

Status LEDs that show you what is happening

Red and blue LEDs on the housing show power and activity. Once the blue light is steady, the drive is ready to copy. You do not need to guess whether the connection took.

Power for 3.5-inch drives, included

The 12V/2A adapter with its 1.2 m lead gives 3.5-inch drives the external power they need to spin up. It comes in the box, so a large desktop drive does not need a second purchase.

Four figures that set the reach and power

• 12V/2APower adapter rating
• 1.2 mPower adapter lead length
• 0.45 mAdapter cable length
• 23 cmCable length on the 23 cm variant

Connect a bare drive in three steps

1. 1
   Power the drive if it is 3.5-inch

   Plug the 12V/2A adapter into the drive's power socket and into the wall. 2.5-inch drives usually skip this step.

2. 2
   Plug in the USB end

   Connect the USB 3.0 Type-A plug to a USB 3.0 port on your computer. The SATA end goes into the drive's blue connector.

3. 3
   Check the LEDs and open the drive

   Wait for the status lights to settle. The drive should appear in your file manager or disk utility. Copy your files, then eject the drive before you unplug it.

Two pieces, one set, both drive sizes covered

• USB 3.0 to SATA adapter cable×1

  0.45 m adapter cable with matte black housing and blue SATA connector

• 12V/2A power adapter×1

  1.2 m lead, UK or US plug depending on your listing variant

One cable between you and your files

The drive you cannot reach

A bare SATA drive from an old desktop sits in a drawer with years of photos or client files on it. Opening the PC to copy them is slow, risky, and close to impossible on a laptop. So the drive stays where it is.

One cable, no teardown

This cable runs from the drive's SATA connector straight to a USB port. There is no enclosure to buy and no case to open. The blue connector and the red and blue LEDs tell you what is connected and powered.

Files back in your hands

Plug in, check the lights, and copy your folders the same afternoon. Backups and recoveries run from your desk, and the old drive stops being a problem you keep postponing.

What to expect from first connection onward

1. First use
   Drive appears on your PC

   Connect the drive, power it if needed, and check that it shows up in your file manager or disk utility. Format and driver steps depend on your operating system and the drive's current partitioning.

2. 3 uses
   Routine backups feel familiar

   After a few sessions you will know which LED pattern means ready and how long your usual copy takes on your machine.

3. 30 days
   Old drives become searchable

   Loose drives you once set aside can be scanned and copied as needed, so older files are easier to find when you need them.

Cable or enclosure: which one fits your desk