Replacement 2.5mm Headphone Cable for ATH-M50X M40X

Built for daily studio wear

• Gold plugs that hold the signal

  Gold-plated contacts sit at both ends, with black strain relief covering the point where the wire meets the plug. That is the spot most cords crack first, so the reinforcement is what keeps a session steady.

• A coil that moves with you

  The matte black rubber jacket stretches to reach from the interface across the desk, then springs back when you let go. You stop fighting slack and tangles while you mix.

• Adapter in the box

  A gold 6.35mm screw-on adapter comes with the cable, so the same headphones plug into 6.35mm jack gear. One purchase covers both connections.

The specs that matter

• 2.5mmConnector end
• 6.35mmAdapter size
• 2Items in box

Swap the cable in a few minutes

1. 1
   Unplug the old cable

   Hold the headphone plug or its strain relief and pull straight out. Pulling by the wire stresses the solder joints.

2. 2
   Seat the 2.5mm plug

   Push the new 2.5mm plug straight into the headphone port until it sits fully home.

3. 3
   Add the adapter if needed

   For 6.35mm gear, thread the gold adapter onto the plug end by hand. Stop when it seats snug.

4. 4
   Test both channels

   Play a familiar reference track and check left and right before you start a session.

Two items, one complete kit

• Coiled replacement cable×1

  Matte black rubber jacket with gold-plated 2.5mm plug and black strain relief

• Gold 6.35mm screw-on adapter×1

  Threads onto the plug end for 6.35mm (1/4 inch) jack gear