Metal Switch Pro Controller Buttons and Thumbstick Caps

Solid metal that you can feel

Solid metal you can feel

Brushed metal caps are firmer and crisper under the thumb than plastic. The press has a clean stop, and the surface stays cool and solid through a long session. Plastic tops go glossy and slick within months. Metal does not.

Knurled grip that holds

The thumbstick rims are knurled, so your thumb finds the edge without searching. Fast movements stay controlled, and the grip holds when your hands get warm halfway through a match.

Engraved symbols

Each action button carries its letter engraved into the metal rather than printed on top. The lettering stays readable as the finish ages, so you are never guessing which button is which mid-game.

The whole kit in four numbers

• 4Metal action buttons
• 2Knurled thumbstick caps
• 4Color-matched finishes
• 1Phillips screwdriver included

Swap them in an afternoon

1. 1
   Power down and clear a table

   Switch the console off, unplug the controller, and lay a towel or cloth on a flat table so no part rolls away.

2. 2
   Remove the worn part

   Use the Phillips screwdriver to loosen the screws, then lift the stock thumbstick cap, D-pad or action button off its stem. Work slowly and keep the screws together.

3. 3
   Seat the metal piece

   Line the metal cap up with the stem before pressing. Press evenly until it sits flat. Do not force it at an angle.

4. 4
   Test before you play

   Press each new button and move each thumbstick through its full range. Every part should move freely with a crisp stop. Adjust any cap that sits crooked before you reassemble.

Everything you need, nothing you don't

• Thumbstick caps×2

  Knurled metal caps with brushed finish

• Metal D-pad×1

  Precision-cut cross pattern

• Metal action buttons×4

  Engraved letters, color-matched

• Phillips screwdriver×1

  Small driver for the swap

The button you stopped trusting

The stick that stopped feeling right

You stopped noticing it slowly. A press drags a little, the thumbstick top has gone smooth and slick, and the whole controller feels lighter than it should. Every session starts with a small compromise you no longer question.

Four pieces, one afternoon

The kit is short on parts and long on payoff: two thumbstick caps, one metal D-pad, four action buttons, and a small Phillips screwdriver in the box. You do not need a workshop. A table, a steady hand and a few minutes are enough to swap every worn piece.

A controller that feels like yours

Solid metal has weight and a crisp stop that plastic cannot copy. Pick the finish that matches your room, and the controller starts to look like it belongs to you. The next session feels like the first one did.

Metal kit vs. plastic caps