DJI Avata Battery Anti-Release Clip, Secure Fixed Buckle

A Fixed Buckle Built for Hard Flying

• Holds the battery where it belongs

  The U-shaped buckle wraps the battery body and resists the small shifts that vibration causes on aggressive flying. The stock latch alone lets the pack creep on freestyle runs. This clip closes that gap, so the battery stays put after the hard landings.

• Buttons stay fully accessible

  The power and function buttons and the storage area stay open. The red dashed guide in the product photos marks the clearance. Tape covers those buttons and leaves residue on the body. This clip does neither, so you power up and change settings without lifting anything off first.

• Precise fit, clean finish

  Molded matte black plastic follows the body contour, so the clip sits flush instead of sticking out. The embossed BRDRC logo is the only detail on the surface. It is compact and lightweight, so the drone flies the way it did before.

Seat it in four steps

1. 1
   Align the U-curve

   Line the curve of the clip up with the battery body before you touch it to the drone.

2. 2
   Press it straight on

   Push the clip down in one straight motion until it seats evenly. Forcing it at an angle can stress the plastic and weaken the hold.

3. 3
   Check the controls

   Confirm the power and function buttons are clear and the switch still moves freely.

4. 4
   Recheck after a hard landing

   After any hard landing or crash, confirm the clip is still seated before you lift off again.