Silicone Cord Clip for Kitchen Walls and Charger Cords

Two channels, one clean line for every cord

• Two channels, zero crossings

  Two parallel channels keep each cord in its own lane. Charger, kettle, and tablet cables run side by side and never cross at the outlet, so you pull one plug without lifting the whole bundle.

• Soft matte silicone grip

  The silicone is matte with smooth, rounded edges. It holds a cord snugly without pinching the jacket, and the flexible body gives under a sudden tug instead of pulling the plug loose from the wall.

• Compact wall footprint

  The body is small enough to sit beside a wall outlet without covering the socket or switch. It fits the gap next to a toaster or along a counter edge, where cords usually drop.

Mount it, slide the cord, walk away

1. 1
   Clean the wall

   Wipe the spot beside the outlet with a dry cloth. Dust and grease weaken the hold, so start with a clean, dry surface.

2. 2
   Press the clip into place

   Press the clip firmly onto the wall at outlet height and hold it in place for a few seconds.

3. 3
   Feed the first cord

   Pull the cord into the central slot, then lay it into the channel that faces the outlet.

4. 4
   Add the second cord

   Route the second cord through the other channel. Let any extra length hang inside the body so the plug stays free.

5. 5
   Walk away

   The cords stay put. When you need to move a device, lift the cord out gently while holding the plug end.