Self-Adhesive Wire Clips No Drilling for Desks & Walls
Cables stay where you put them without a single hole in the wall. Each clip goes on in seconds, grips the cable in an open R-shaped channel, and blends into desks, TV stands and bedside tables.
Read the full descriptionDescription
Cables stay where you put them without a single hole in the wall. Each clip goes on in seconds, grips the cable in an open R-shaped channel, and blends into desks, TV stands and bedside tables.
Tidy cables in seconds with self-adhesive clips, no punching holes
- Loose cables cluttering desks and walls
- Cannot drill holes in rentals or walls
- Cables sliding off surfaces
Tidy every cable in seconds, without a single hole
Loose cables sliding off your desk and hanging behind the TV, with no drilling allowed. After: each run is clipped in place with a self-adhesive R-channel and the wall stays untouched.
One open channel that holds the cable, not the wall
- An open R-channel that holds the cable
The open curved channel seats a cable without pinching it and holds bundles up to roughly 8 x 5 mm. The clip grips the cable itself, so nothing depends on a screw, an anchor or a fixed tie point.
- Mounts with no drilling
The self-adhesive base sticks to clean, dry surfaces with no drilling and no punched holes. Set it on a desk edge, the back of a TV stand or a nightstand side panel, and the surface stays free of holes.
- Transparent body that blends in
The translucent frosted body is clear enough to fade into most surfaces. Once the cables are routed, the clip reads as part of the run instead of a bracket.
Clean the surface, press, route the cable
- 1Wipe the surface
Use a dry cloth on the spot where the clip will sit. Let it dry fully, since dust and oil stop the adhesive from bonding.
- 2Press and hold
Press the clip firmly onto the surface and hold for a few seconds so the adhesive takes hold.
- 3Seat the cable
Slide the cable into the open curved channel. It should sit without force and stay where you put it.
- 4Check the run
Gently tug the cable to confirm the clip holds. Route the rest of the run through the next clip along the same path.
Small enough to tuck under the desk
- 14 x 14 mmBase
- 8 mmHeight
- 7 mmDepth
- 8 x 5 mmChannel opening
A compact clip that sits flat against the surface
Characteristics
Reviews
Questions and answers
It can, if the clip is pulled off quickly. Clean and dry the surface before mounting, then warm the clip gently with a hairdryer and lift one edge slowly. Test on a hidden spot first if the wall finish is delicate.
Smooth, clean and dry surfaces give the strongest bond. Dusty, oily or heavily textured surfaces grip less, so wipe them first or add a second clip to the run.
The channel opening measures 8 x 5 mm. Single cables and small bundles sit well inside that. For thicker bundles, split the cables into smaller groups and give each group its own clip.
The two backings are sold as separate variants. The foam version has a white skin adhesive pad, and the acrylic version has a transparent pad that suits clear mounting surfaces. Pick the variant that matches the surface you plan to use.
You can lift it and reseat it on a clean surface. Each reseat leaves a little less grip than the first press, so plan the spot before you peel the backing.
A pack includes 50 clips, which covers a desk run, a TV stand, a bedside outlet and a car console with clips to spare. Compared with replacing tape that loses grip, a set of clips you can move from one setup to the next costs less over time and keeps the cables where you put them.