Waterproof Bathroom Sealing Strip, Self-Adhesive PVC Tape

One strip, one clean seal along every join

• Concave profile that fills the gap

  The curved PVC profile sits inside the wall-to-bath join and fills the space a flat sticker would leave open. The strip bends with the join, so it follows the curve of the tub instead of bridging it. The edge stays flush against the tile once it is pressed in.

• Peel-and-press self-adhesive backing

  The adhesive bonds to a clean, dry surface, so the strip goes on without a caulk gun, masking tape or a cure window. Peel back a short section of liner, press it along the join and smooth as you go. Work on a dry wall and the bond holds.

• Rolled for storage, ready to cut

  The strip comes as a full roll that stores flat in a drawer or cupboard. Cut it to the length of each join, and the adhesive tab at the end gives you a clean starting point. Keep the leftover roll for the next gap, whether that is the sink or a kitchen counter.

Clean it, peel it, press it in place

1. 1
   Clean the join

   Wipe the bath edge, tile and sink rim with a damp cloth to lift soap scum, then go over it with a dry cloth. Dust and film stop the adhesive from gripping.

2. 2
   Dry it fully

   Let the join dry completely before you peel anything. Moisture blocks the bond and can lift the strip early, letting water back in behind it.

3. 3
   Peel the backing

   Pull the liner back in short sections so the adhesive stays clean. The backing is smooth and tacky, ready to bond.

4. 4
   Press it along the join

   Lay the strip into the gap and press in short runs, smoothing as you go. Do not stretch it taut. Stretched PVC pulls back toward its roll shape and can leave gaps at the ends.

Roll size, material and what you get

• White PVC sealing strip×1

  Roll measures 3.2m x 3.8m as listed

• Self-adhesive backing

  Peel and press, no caulk or tools needed

• Matte white finish

  Soft matte surface, flexible enough to follow curves