Foldable LED Ring Light with 1.68m Stand for Selfies
Even, flattering light for selfies, makeup and livestreams, from a ring that folds down small enough for a drawer. Ten brightness levels and three colour modes let you match the room and your skin tone. The 1.68m stand puts the light at eye level without a studio corner.
Read the full descriptionDescription
Even, flattering light for selfies, makeup and livestreams, from a ring that folds down small enough for a drawer. Ten brightness levels and three colour modes let you match the room and your skin tone. The 1.68m stand puts the light at eye level without a studio corner.
Foldable, dimmable LED ring light with a 1.68m stand for flattering selfies, videos and makeup
- Harsh or uneven lighting for selfies and makeup
- Need for a stand that is adjustable in height
- Bulky lighting gear that is hard to store
Flattering light, wherever your phone points
Harsh shadows and uneven makeup light turn every selfie into a retake. This foldable ring with a 1.68m stand gives you even, dimmable light in seconds.
Ten levels of light, three moods to match

Ten levels to dial in the mood
Ten dimming levels take the ring from a soft glow for close-up makeup to a bright fill for wide shots. The demo photos show the same face at 35%, 65% and 100%, and the difference on camera is obvious. Start mid-range, then nudge up or down while you watch the preview on your screen.

Three colour modes, one ring
White, warm and warm white give you three looks from one light. Warm suits evening rooms and flatters skin, cool white helps you check foundation against the shade you actually wear, and warm white sits between the two for mixed daylight. You switch modes on the ring itself, so the room does not need to change.

Reaches 1.68m, folds flat
The telescoping stand extends to 1.68m, which puts the ring at eye level for seated makeup, standing selfies or a desk livestream. The base folds down to a disc, so the whole kit fits in a drawer or a bag between sessions.
Built to reach eye level from almost anywhere
- 1.68mTelescoping stand height
- 10Brightness levels
- 3Colour modes
From box to first selfie in minutes
- 1Open the box
Lift out the matte black ring. The LED edge is smooth and the ring feels light in your hand.
- 2Unfold the base
The folding disc opens flat and locks in place. Set it on a desk and check that it sits steady before you add height.
- 3Extend the stand
Pull the telescoping stand to full height. Twist each lock firmly so the sections hold.
- 4Clamp your phone
Slide the adjustable clamp onto the ring and tighten it over your phone. Angle the ring toward your face.
Everything you need, nothing to assemble twice
- LED ring light×1
Dimmable, ten brightness levels and three colour modes
- Telescoping stand with folding base×1
Extends to 1.68m and folds to a compact disc
- Phone holder clamp×1
Adjustable clamp that attaches to the ring
The light was never your problem
The shadow that ruined the take
You hit record, and the overhead bulb carves a shadow under your nose and lights your forehead like a headlamp. The footage looks muddy, so you delete it and start the makeup over. Every bad session costs more than the hour you spent on it.
Set it, dim it, shoot it
Clip your phone to the ring, bring the stand to eye level and turn the dial. Ten brightness levels let you go soft for close-up foundation work or bright for a wide shot. Switch between white, warm and warm white until the skin looks like your skin. The first take is usually the one you keep.
Fold it away until next time
When the video is posted, the base folds into a compact disc and the stand slides down small enough for a drawer or a shelf. There is nothing to rearrange in the room, so the setup stays ready for the next routine.
What to expect as you shoot
- First useYour first evenly lit selfie
Set the ring at eye level, pick a comfortable brightness and shoot. Your face should look evenly lit with fewer harsh shadows than an overhead lamp.
- 3 usesYour go-to brightness found
After a few sessions you will know which of the ten levels suits your room and makeup routine. Setup should take about a minute.
- 30 daysFilming becomes a routine
Folding it away after each session becomes habit. You can film makeup or lessons without rearranging the room each time.
Why not just use the lamp on your desk
| This ring light | Desk clip light | Studio light kit | |
|---|---|---|---|
| Dimmable | Yes | No | Yes |
| Colour modes | Yes | No | Yes |
| Folds flat for storage | Yes | Partial | No |
| Adjustable height to eye level | Yes | No | Yes |
| Phone clamp included | Yes | Partial | No |
Characteristics
Reviews
Questions and answers
The clamp fits over the ring and holds a phone in place. The ring runs on USB power, so you can plug it into a wall adapter, a laptop or a power bank. A bank is only needed if you film away from an outlet.
Each telescoping section locks when you twist it, and the folding disc base sits flat on a desk. Extend one section at a time and lock it before you clamp the phone, and the ring stays put through a full session.
Yes. Place the base on your desk, run the stand up behind the webcam and set warm white to match the room. The clamp holds a phone, so a tablet is a question of fit, while the ring itself works with any camera.
White is the most neutral and suits daylight-matched colour checks. Warm adds a golden tone that flatters skin in evening rooms. Warm white sits between the two, which works well when window light and the room lamp are both on.
The base folds down into a flat disc, and the stand collapses as the sections slide back. The whole kit fits in a drawer or a bag, so you can put it away after each session without rearranging the room.
A studio kit needs a dedicated corner, separate stands and loose cables. This ring gives you ten brightness levels and three colour modes in one folding unit, which covers most of the work a small studio kit does for makeup and selfie filming.
Similar products
See all





