Warm Recessed Stair Light with Motion Sensor, IP65
Soft, warm light across every step, with the source hidden in a flush recessed frame. The louver keeps the glow off your eyes, and the matte charcoal housing looks right on a finished wall indoors or out.
Read the full descriptionDescription
Soft, warm light across every step, with the source hidden in a flush recessed frame. The louver keeps the glow off your eyes, and the matte charcoal housing looks right on a finished wall indoors or out.
Soft, glare-free warm step lighting that makes stairs and walkways safer and more stylish
- dark or unlit stairs and steps
- harsh glare from exposed lights
- uneven or spotty floor illumination
- visible bulky fixtures on walls
Walk your stairs in soft, glare-free warm light
Dark stairs and bare bulbs make every night trip a guess. This recessed warm light turns on as you approach and lays a calm glow across each step.
Light that lands where your feet go

Light aimed at the tread, not your eyes
The louver is asymmetric, so light falls down and across the step while the bulb stays out of your line of sight. Floors and skirting boards pick up a soft pool of warm light, and the edge of each step reads clearly from the top.

Weatherproof IP65 build
The charcoal housing carries an IP65 rating, which means it is dust-tight and protected against water jets. It suits steps and garden walls that take rain and dust. Seal the cable entry and the recess edge before you close the wall.

Compact 1W warm glow
A 1W warm white LED gives a low level glow built for steps and paths, not general room light. Place several units along a stair or route for an even look. One unit lights a tread well, and a run of them makes the whole flight easy to read.
What you will open
- Recessed step light housing×1
Square matte charcoal body with the ribbed asymmetric louver
- Controller×1
Runs the light and sensor setup
- Mounting hardware
Parts for a recessed fit in a wall or riser
- Installation guide×1
Covers wiring, sensor setup and IP65 sealing points
Every night trip starts with a guess

The dark step you know too well
Night trips start with a hand feeling along the wall for a switch. Each unlit tread is a guess, and the one you misjudge is the one that catches you. Most people have a story about that step.
Glare is not the answer
Bare bulbs feel like the fix until one blinds you on the way down. Bulky plug-in motion pucks look cheap on a finished wall. The problem was never a lack of light. It was where the light came from.
Soft light, hidden source
A flush recessed unit with an asymmetric ribbed louver changes that. Motion wakes it as you approach, and the louver throws a warm pool onto each tread with the source tucked out of eye level. Stairs read clearly, and the wall stays clean. If the route is a hallway, night lights pair well with the same calm glow.
What to expect after install
- First useLight turns on as you approach
The sensor picks up movement and the warm glow lights the step before your foot lands. Check that the trigger range suits your stair.
- Week 1Night trips feel calmer
You stop reaching for the switch on the way to the bathroom. Adjust the sensor angle if it triggers from the wrong spot.
- 30 daysLighting feels like part of the room
The fixture blends into the wall, and the warm pool on the floor becomes the normal look of the space at night.
Flush and compact, built to disappear
- Square housingShape
- Recessed, flush to wall, step or skirtingMount
- CompactSize
- Matte textured charcoalFinish
Small enough to sit in a tight riser or wall recess
Why this, not that
| This | Plug-in motion puck | Exposed wall sconce | |
|---|---|---|---|
| Flush recessed fit | — | — | |
| Light source hidden from eye level | — | — | |
| Motion activation | — | ||
| Built-in look on a finished wall | — | — |
Characteristics
Reviews
Questions and answers
Yes, for the job it is built for. A 1W warm LED lights each tread and the floor edge at a low level, which is what you want on a stair at night. It is not a room light. Space several units along the run, and the glow adds up into an even path.
The sensor version comes with its own controller, so you wire it in the wall rather than adding a separate box. The variant listed as No sensor does not include motion detection. Check the wiring diagram in the guide before you open the wall, and use a qualified electrician if you are not sure.
IP65 means dust-tight and protected against water jets, which covers rain on an outdoor step or garden wall. The rating depends on a proper seal, so fit the cable entry and recess edge with gasket before closing the wall.
Yes. The square housing is made for a recessed fit, with mounting hardware in the box. Measure the recess first. It is compact enough for tight risers, and the flush finish is what keeps it looking built in rather than fitted on.
A plug-in puck sits on the wall and reads as an add-on. A flush recessed unit costs one install and then disappears into the finish, with the light aimed down onto the tread. For a stair you walk every day, that is the lower-maintenance and cleaner choice.
Similar products
See all






