Punch-Free Towel Bar for Renters: No-Drill Bathroom Rack

Mounts on the wall, not into it

• Stick it on, not into the wall

  Clear adhesive pads hold the bar flat against the wall. No drill, no punched plaster, no dust on the floor. Wipe the wall dry, press each mount firmly, and the bar is up in minutes. When you move out, peel the mounts slowly as the included instructions say and skip the patch-and-paint job that drilled holes leave behind.

• Room for towels and slippers

  The lengthened curved bar gives a full bath towel room to hang without bunching. Slippers can sit on the lower stretch of the bar and dry out of the way. The floor stays clear, and the door stops being the only place a towel can go.

• Lids and hangers too

  Hang a pot lid or a lightweight hanger on the bar and the counter stays open. The same bar that holds a towel by the tub works in a small kitchen, so you are not buying a second organizer for the cooking side of the flat.

Up on the wall in four steps

1. 1
   Open the box

   Inside you will find the smooth, glossy plastic bar with its curved profile, plus the adhesive wall mounts. The bar comes in teal, orange or yellow.

2. 2
   Check the mounts

   Peel the protective film from one clear adhesive pad. The pads are nearly invisible on the wall, which is the point if your lease rules out holes.

3. 3
   Pick your spot and clean the wall

   Choose a height where towels hang clear of the tub and slippers can sit below. Wipe the wall dry and free of dust, then press each mount firmly in place.

4. 4
   Hang it up

   Slide the bar onto the mounts and check that it sits level. Drape a towel over it and let it settle. Follow the included instructions on the adhesive before you load it heavily.

Everything you need, nothing you don't

• Punch-free towel bar×1

  Lengthened curved bar in teal, orange or yellow

• Adhesive wall mounts

  Transparent pads, no drilling or tools needed