Weed Puller for Driveway Cracks, Stand-Up Steel Head
Weeds in driveway and sidewalk seams stop being a knee-breaking chore once you work from a standing position. This steel head clips onto the long handle you already own, rolls along the crack on two bearing wheels and lifts the weed with a pointed spike. Your back gets a rest, and the edge stays clean.
Read the full descriptionDescription
Weeds in driveway and sidewalk seams stop being a knee-breaking chore once you work from a standing position. This steel head clips onto the long handle you already own, rolls along the crack on two bearing wheels and lifts the weed with a pointed spike. Your back gets a rest, and the edge stays clean.
Remove driveway and sidewalk weeds without kneeling
- kneeling and back strain while weeding
- weeds growing in driveway and sidewalk cracks
- hard-to-reach weeds along edges
Remove driveway weeds without kneeling
Crack-by-crack weeding on your knees leaves your back sore and the seams still green. This steel head clips onto the handle you already own, so the weeds come out while you stand.
Built to Work the Cracks Standing Up
- Pull weeds from seams standing
The pointed spike sits at the front of the head and slides into the gap between slabs. Pull back and the root comes up with it. You stay upright the whole time, so a crack that used to cost you a stretch on your knees takes a few passes.
- Rolls the seam clean
Two rubber wheels ride on metal bearings, so the head glides along the crack instead of skipping over it. The wheels hold the spike in the gap from the first foot to the last, which keeps the pull steady.
- Fits the handle you own
The steel connector tube clamps onto the handle with wing-nut clamps, and it fits any handle. Tighten it by hand, set the angle, and the tool is ready. There is no second tool to store in the garage.
Four Steps From Handle to Clean Seam
- 1Clip the head on
Slide the steel connector tube onto your handle and tighten the wing-nut clamps by hand.
- 2Set the angle
Adjust the angle on the handle so the spike sits low and the wheels rest flat on the surface.
- 3Roll along the seam
Walk the head along the crack. The wheels keep the spike seated in the gap.
- 4Lift the weed
Pull back on the handle. The spike lifts the weed and its root out of the seam while you stay upright.
What Arrives in the Box
- Steel connector tube×1
Slides onto the handle and carries the head.
- Wing-nut clamps
Tighten by hand to lock the connector on any handle.
- Rubber wheels with metal bearings×2
Ride along the seam and keep the spike steady.
- Pointed weeding spike head×1
Lifts weeds and roots from concrete cracks.
Characteristics
Reviews
Questions and answers
Yes. The steel connector tube fits any handle, and the wing-nut clamps tighten onto it by hand. Use the broom, rake or long-handled tool you already keep by the door. Nothing else needs to be bought.
The head is steel with a pointed spike, which lifts roots out of concrete seams. Very deep taproots may still need a second pass with a hand tool, but the spike clears most of the crack in one pull.
Yes. The two wheels ride along the seam and the spike follows the gap, so the head works the edge where the sidewalk meets the lawn. The adjustable angle on the handle lets you set the spike low for tight cracks.
Knock off the soil and wipe the spike and wheels before you hang it up. The matte black finish and open wheel design make that a quick job, and a clean head keeps the bearings turning freely.
Think about what it replaces. Every crack you clear on your knees costs you time and a sore back afterward. This is one purchase that lives on a handle you already own, so the next weekend session starts standing up.
Similar products
See all