Cantilever Patio Umbrella: Open Shade With No Centre Pole

Shade that starts where the pole would be

• A curved arm that clears the table

  The steel arm reaches out from the side, so the canopy covers the seats and nothing stands in the middle of the table. Your knees and elbows have room, and guests can pull their chairs in without working around a pole.

• One crank to lift and tilt

  The chrome handle raises the canopy and tilts it in the same movement. When the sun drops toward the lawn, you turn the crank and the shade follows. It takes a few seconds, and you do not need to stand up from the table to do it.

• A black base for steady shade

  The black base sits under the frame and gives the arm a firm footing. Set it on level ground and add weight as the instructions advise, and the canopy stays where you put it while you sit underneath.

One crank to follow the sun

1. 1
   Set the base on level ground

   Place the black cross base on flat, firm ground and add weight to it before you raise the canopy.

2. 2
   Attach the cantilever arm

   Fit the curved steel arm to the frame so the canopy sits over the seats rather than over the table centre.

3. 3
   Lift the canopy with the crank

   Turn the chrome crank to raise the canopy to the height you need, stopping at the end of its travel.

4. 4
   Tilt it toward the sun

   Use the same crank to angle the canopy as the sun moves across the lawn or terrace through the afternoon.

Four pieces, ready to assemble

• Umbrella canopy×1

  Lime green, forest green or burgundy polyester with ribs

• Steel frame and cantilever arm×1

  Matte black steel with a curved offset arm

• Crank handle×1

  Chrome crank for lifting and tilting the canopy

• Cross base×1

  Black base for a steady footprint under the frame

The pole was never the best place for shade

The pole in the middle

Most patio tables were set up around a post. You pull the chairs in close, lean sideways to dodge the pole, and still end up squinting by three o'clock. The seat you actually want is the one that sits in full sun.

Shade that moves with the sun

An offset arm lets the canopy hang over the seat instead of over a post. When the light swings west, one turn of the chrome crank tilts the canopy back over the bench. You stop chasing shade across the lawn.

Your patio, finally set right

Chairs can sit where they fit best, the table stays clear, and the shade lands on the people who are sitting in it. The afternoon stays comfortable without a second trip outside to move things around.

From first setup to daily shade

1. First use
   Assemble and position the arm

   Set the base, attach the arm and check that the canopy clears your table and chairs before the first full afternoon.

2. 3 uses
   Learn the crank rhythm

   After a few adjustments you know how far to lift and tilt the canopy as the sun moves. The motion becomes second nature.

3. 30 days
   Shade becomes routine

   Over a month of sunny days you reposition the canopy by habit, and the seating you use most stays clear of any pole.

Why this, not a centre pole