Cable Organizer Clips for Desk, Silicone Cable Holder
Your charger, earbud wire and mouse cable stay where you reached them. This flat silicone bar sticks to the desk edge with double-sided adhesive and holds seven cables in separate grooves. It is built for cables under 5mm and takes up very little room.
Read the full descriptionDescription
Your charger, earbud wire and mouse cable stay where you reached them. This flat silicone bar sticks to the desk edge with double-sided adhesive and holds seven cables in separate grooves. It is built for cables under 5mm and takes up very little room.
Keeps charging cables and earphone wires neatly organized on your desk with a seamless adhesive mount
- tangled charging cables
- cables sliding off the desk
- messy desk setup
- cords hanging loose behind devices
Cables that stay put, right where you reach
Tangled chargers and cords sliding off the desk are a daily hassle. Seven silicone grooves hold each cable in place, so your desk stays clear and tidy.
One strip, seven cables, zero tangles
Seven grooves for seven cables
Seven separate grooves keep each cable in its own slot, so a phone line never ends up knotted around a mouse cord. The bar measures 150 mm long, 20 mm wide and 12 mm high, a compact footprint that leaves room for your keyboard and notebook.
Flat adhesive mount
The back is double-sided adhesive that sits flush with no visible trace once it is down. Wipe the desk, keep the surface flat, and press the bar on. The bar stays where you put it, so there is no clamp to tighten and nothing to slide under the desk.
Built for cables under 5mm
The grooves are sized for cables under 5mm, which covers Lightning and USB charging cables and most earphone wires. Thick laptop cords and braided power leads will not seat properly, so keep those in a separate holder. cable organizers in a bigger size are the right pick for them.
Stick it flat, then leave it alone
- 1Wipe the desk
Clean the spot with a dry cloth so dust and oil do not weaken the adhesive.
- 2Check the surface is flat
Keep the desktop flat before you paste the bar. Curved or uneven edges will not hold the tape.
- 3Press the bar down
Peel the backing, line the bar up with the desk edge, and press firmly along its full length.
- 4Seat the cables
Press each cable under 5mm into its own groove. Skip the thicker cords, and do not peel the bar off to reposition it.
A compact bar for tight desk edges
- 150 mm (15 cm)Length
- 20 mmWidth
- 12 mmHeight
- Under 5 mmCable limit
About the length of a smartphone lying flat
Characteristics
Reviews
Questions and answers
No. The grooves are sized for cables under 5mm. A thick laptop charger or a braided cord will sit loose, or push the silicone out of shape over time. Measure the cable before you buy, and use a larger holder for bulky leads.
The double-sided tape is made to hold firm, so take it slowly when you lift the bar. Peel from one corner at a low angle. How cleanly it lifts depends on your desk finish, so try a hidden corner first.
Use it on a flat, clean surface. Adhesive bonds weakly to dust, oil, and curved edges. Smooth wood, laminate, or a flat desk top is where it sticks best.
Seven, one per groove. A phone charger, an earbud wire, a mouse cord and a tablet cable can all share the bar. Two cables in one groove will not sit well, so give each cord its own slot.
The bar is soft matte silicone in a grey finish, and it has a light, budget build. It holds cables firmly when mounted flat, but it is a small accessory, not a metal fixture. At the cost of one bar, you stop searching for loose cords every time you charge.
Similar products
See all
Cable Organizer Clips for Desk, Silicone Cable Holder