White Vinyl Fence Line Post with Pre-Cut Rail Holes
A straight white fence line that goes up in an afternoon. The rail openings are already routed into each post, so the rails slide through and the run stays aligned from end to end. Each post finishes with a cap that sends water off the top.
Read the full descriptionDescription
A straight white fence line that goes up in an afternoon. The rail openings are already routed into each post, so the rails slide through and the run stays aligned from end to end. Each post finishes with a cap that sends water off the top.
Pre-cut routing holes for a fast, tool-light vinyl fence line
- drilling or cutting holes for rails on site
- misaligned fence rails between posts
- exposed post tops collecting water
Build a straight white fence line without drilling on site
Skip the measuring, marking and drilling that makes a DIY fence slow and crooked. Set the posts, slide in the rails, and finish with a sealed white cap on top.
Rail holes cut before the post reaches your yard
- Rail holes already routed
The rectangular openings are cut into the post face before it leaves the factory. Each rail slides straight through, so the run stays level from post to post without a marking pass or a drill bit on site.
- Caps that seal the top
The pyramid cap sits over the open top of the post and turns rain away from the hollow profile. A bare post collects water and stains faster, so the cap keeps the top clean. Each post comes with its own cap.
- A base built to sit firm
The hollow square profile tapers toward the base, so the bottom of the post is narrower than the top. A small rectangular hole sits near the bottom of the same profile. Set the post plumb and tamp the soil firmly around it.
Set the line in four steps
- 1Set the corner and end posts first
Place the anchor posts at each end of the run and check them plumb. Every line post between them takes its height and spacing from these two.
- 2Place the line posts between them
Stand each line post at matching spacing with its rail openings facing the run. Check the openings line up across the section before you tamp the soil.
- 3Slide the rails through the openings
Feed each rail straight through the pre-cut openings from post to post. The rails should sit level without any drilling or cutting on site.
- 4Press the caps onto each post top
Once the run is square, press a cap onto every post top. The cap sits flush and finishes the line with a clean, sealed white top.
Characteristics
Reviews
Questions and answers
The rectangular openings are cut into the post face to take rails that slide in and route through, the way a routed vinyl fence is built. Measure your rail width and height against the opening before you order. Match the post height to the posts already in your run so the top rails land level.
A line post sits between the end and corner posts and holds the fence panels upright, which is its job in this system. Set it plumb and tamp the soil firmly around the base. No load rating is listed for this post, so ask the seller before you build a long, exposed run or a windy stretch.
Each post includes a pyramid cap that covers the open top. Water runs off the sides of the cap instead of pooling inside the hollow profile, and a clean cap keeps the top looking white for longer.
The set has two line posts and two caps. That covers a short section, an extension, or a repair. A full run also needs corner and end posts plus line posts at your spacing, so order more sets to match the length of your fence.
Premium vinyl costs more than bare wood or basic plastic, but it does not need painting or staining. Compare two posts with caps against a rented drill, a template and a weekend of re-cutting rails that still come out uneven. The routed openings are the time you do not spend on site.