USB to DC 2.5mm Replacement Power Cord for Moon Lamp

Two connectors, one job: powering your lamp

• Fits the 2.5mm barrel

  The DC 2.5mm barrel is the connector your lamp expects. Check the socket on your lamp base before you order. The yellow-tipped center pin and ribbed strain relief sit right at the end of the cord, so the barrel seats straight and stays put.

• Plugs into any USB-A port

  The standard USB-A plug works with laptops, power banks, and USB wall adapters. Plug it into any of them and the lamp lights from that source, with no separate adapter to buy or lose.

• One 1 m cord

  At about 1 m, the cord reaches a nightstand or desk without an extension. It arrives coiled and held by a cable tie, so it stays tidy in a drawer or bag.

Plug in and light it up

1. 1
   Check the rating

   Read the 2C-1A rating on the jacket and the voltage label on your lamp. Make sure the USB source you plan to use can supply that current.

2. 2
   Seat the barrel

   Line up the 2.5mm DC barrel with the lamp socket and push straight in with light pressure. Do not force it, since a bent center pin is hard to fix.

3. 3
   Plug into a USB source

   Connect the USB-A end to a laptop port, a power bank, or a USB wall adapter.

4. 4
   Switch on and check

   If the lamp lights, the connection is good. Keep the spare length coiled and off the floor so it does not get stepped on.