USB Heated Ankle Wrap with 5 Heat Levels and Massage

Five heat levels you set yourself

• Set your exact warmth

  Five presets run from 40 to 60°C, and the wrap starts at 50°C unless you choose otherwise. Press the heat button to step through the levels, or press it again to turn heating off. Start at 40°C on your first evening and move up once you know what feels right.

• Gentle massage built in

  The plush lining holds massage nodes that work the ankle while the heat runs. Three gears cover light to firmer pressure, and the vibration button cycles through them. Turn it off with one press when you want heat only.

• Timer that shuts off

  The auto timer ends heating after 30 minutes, so a session never runs on by accident. Hold the power button for 2 seconds to shut the wrap down early. The controller is removable, so you can keep it clipped where you can reach it.

Heat, massage, and timing in numbers

• 40-60°CAdjustable heat range
• 5 levelsHeat settings from 40 to 60°C
• 3 gearsMassage modes in the plush lining
• 30 minAuto shut-off timer

Wrap, press, and settle in

1. 1
   Charge the wrap

   If the controller does not light up, connect the attached USB cable to a power source until it is ready.

2. 2
   Wrap and power on

   Place the wrap on the ankle and fasten the hook-and-loop strap. Press and hold the power button for 2 seconds until it beeps twice.

3. 3
   Set the heat

   The wrap starts at 50°C. Press the heat button to cycle 40, 45, 50, 55 and 60°C, or press it again to turn heating off.

4. 4
   Add massage if you want it

   Press the vibration button to cycle massage gears 1 to 3. Press it again to turn vibration off.

5. 5
   Shut down when you finish

   Press and hold the power button for 2 seconds to shut down. The 30-minute timer also ends the session on its own.

Wrap, controller, and charging cable

• Heated ankle wrap×1

  Fleece-lined with massage nodes and a non-slip base

• Removable touch controller×1

  LED display for heat level and timer

• USB charging cable×1

  Charges the wrap

Evenings that stop feeling heavy

The ache that follows you home

Standing through a shift or sitting at a desk for hours leaves ankles stiff and achy by evening. Cold feet make it worse, and ice feels harsh on a joint that already hurts. Most people push through it and hope it passes by morning.

Warmth you choose

The wrap runs in five steps from 40 to 60°C, so you pick the level your ankle can take that night. Three massage gears sit under the fleece and work the joint while the heat soaks in. You are the one setting the pace, not a fixed heating pad.

An evening that loosens up

Put the wrap on while you watch TV or work at the desk. The 30-minute timer ends the session on its own, so you can stop thinking about it. Your ankles feel warm and loose, and the evening stays easy.

What to expect over time

1. First use
   Learn your controls

   Press power for 2 seconds, set heat with the heat button, and try the massage gears. Start at 40°C if you are unsure, then move up as it feels comfortable.

2. 3 uses
   Find your go-to setting

   Most people settle on one heat level and one massage gear that suits their routine. Keep each session within the 30-minute timer.

3. 30 days
   Build a simple routine

   A regular evening session makes the habit easy to keep. If pain persists, see a doctor, because the wrap is not a substitute for medical care.

Actual size

• 37.5 cmLength
• 9 cmWidth
• 3 cmThickness

Roughly the length of a standard school ruler