Ultrasonic Rodent Repeller with 4 Modes, 360° Coverage

Built for the corners you cannot check

• Switch the signal, not the unit

  TEST, ULTRA, TRANS, and DUO sit on the unit itself. Pick the mode that suits the room and change it later without buying a second device. Rodents adapt to one pattern, so the ability to rotate is the point.

• Pressure waves and ultrasonic sound in one housing

  Pressure waves and ultrasonic sound come from the same unit. DUO mode runs both together, which covers more of what is going on in a kitchen or shed than a single-frequency plug-in does.

• One unit, one adapter, no aiming

  The box holds the repeller and its AC power adapter, nothing else to assemble. Its 360 degree design means you place it in the open and let it cover the area around it. The indicator LEDs confirm it is running.

The specs that matter

• 360°Coverage around the unit, no aiming needed
• 4Selectable modes: TEST, ULTRA, TRANS, DUO
• 2 pcsRepeller unit and AC power adapter

Set it up in five steps

1. 1
   Plug in the adapter

   Connect the AC power adapter to the unit and plug it into a wall outlet. Use a dry, covered outlet in garages, sheds, and outdoor areas.

2. 2
   Press TEST

   Press TEST and check that the indicator LED lights. This confirms power only. It does not show that rodents have left.

3. 3
   Pick a mode for the room

   Start with DUO in the pantry or kitchen for the first week, ULTRA in a garage or shed, and TRANS for an outdoor post facing a garden bed.

4. 4
   Place it in the open

   Set the unit at about desk height with a clear line to the room. Keep it away from walls, cabinets, and furniture that block the signal.

5. 5
   Rotate and reseal

   Change modes every week or so, close food containers, and seal gaps. Check for new droppings in week four and adjust placement if they keep appearing.

Two items, nothing else to buy

• Pest repeller unit×1

  Matte black top, ribbed base, four function switches

• AC power adapter×1

  Powers the unit from a standard wall outlet

From scratching in the wall to quiet rooms

1. 1
   The scratching starts at 2am

   You hear it inside the wall, then notice the pantry is no longer yours alone. Snap traps need constant checking, poison puts pets and children at risk, and sprays fade within days. The question becomes which room they use next.

2. 2
   One unit, two signals

   This plug-in pairs pressure waves with ultrasonic sound from a single housing. The 360 degree output reaches the area around the unit, so you do not need to aim it at a corner. Plug it into the kitchen, garage, or shed and it runs on its own.

3. 3
   Switch modes when the signal gets stale

   Four switches let you pick ULTRA, TRANS, DUO, or TEST. Rotate between them every week or so, because rodents adapt to a single pattern. The red and green indicator LEDs tell you the unit is powered and working.

4. 4
   The rooms you stopped checking

   Once the unit is in place and the food is sealed, the pantry stays clear and the garage stops smelling of mouse. The rooms you had stopped checking are quiet again, and you sleep through the night.

What to expect over the first weeks

1. First use
   Confirm the unit is powered

   Press TEST and check that the indicator LED lights. Walk the room and note where activity was seen.

2. Week 1
   Cycle through the modes

   Try ULTRA, TRANS, and DUO in the room with the most activity. Keep one mode running for several days before switching so you can judge it fairly.

3. Week 4
   Review sealing and food storage

   Closed food containers and sealed gaps make the biggest difference. Check for new droppings and adjust placement or sealing as needed.

How it stacks up against the usual fixes