Traceless Wall Mop Rack for Bathroom & Kitchen Storage
Your mop and broom leave the floor and the wall stays unmarked. A two-tone clip with a U-shaped clamp and red press buttons holds the handle at a height you can reach, and the self-adhesive pad mounts it without a drill. The rack suits tight bathrooms, kitchens and laundry corners.
Read the full descriptionDescription
Your mop and broom leave the floor and the wall stays unmarked. A two-tone clip with a U-shaped clamp and red press buttons holds the handle at a height you can reach, and the self-adhesive pad mounts it without a drill. The rack suits tight bathrooms, kitchens and laundry corners.
Nail-free, traceless wall mount that holds mops and brooms neatly off the floor
- mops and brooms falling over or cluttering floor space
- wall damage from drilling or nails
- messy storage in bathrooms and kitchens
Get your mop off the floor, keep the wall clean
Mops and brooms slump across the bathroom floor and the wall gets scuffed by every failed attempt at storage. This two-tone clip holds them up and off the floor, then comes down without a trace.
One clamp, two tools, zero clutter
- Holds the handle without a nail
Clear self-adhesive pads sit flat on the back of each clip. Wipe the wall clean, press the pad firmly, and the clip is ready to take a handle. Renters get a rack that stays put during daily use and comes off when the lease ends, with no holes to patch. If you are shopping for a wall hooks alternative that will not leave marks, this is the one that matters.
- A clamp that grips both tools
The U-shaped clamp takes mop and broom poles alike. A red press button locks the handle in place, and a press releases it, so one hand is enough to lift the tool out. The clamp suits the common metal and wood poles in household use, and thicker shafts simply need a firmer press to seat.
- Side hook for small extras
The side hook carries a brush, a dustpan or another light item beside the main tool. It keeps the cleaning kit in one place instead of spreading it across the floor. Keep heavy wet buckets on the floor, since the hook is built for light loads.
Mounted in minutes, no drill needed
- 1Clean the wall
Wipe the spot clean and dry. Dust and grease weaken the adhesive, so skip this step at your own risk.
- 2Press the adhesive pad
Press the translucent pad firmly onto the wall and hold for a few seconds. Let it settle before you load anything.
- 3Seat the clamp
Slide the mop or broom pole into the U-shaped clamp at handle height.
- 4Lock with the red button
Press the red button to lock the handle. Hang a brush or small item from the side hook if you need it.
Keep the pad clean so it holds
- Wipe the pad dry
Clean the wall and the pad area with a dry cloth if dust builds up. Moisture and grime are the main reasons a pad loses grip.
- Check it now and then
If the clip starts to lift, press the pad back down firmly.
- Peel slowly
Lift one edge and peel the pad back gently. Warm it lightly with a hair dryer if it resists, so paint stays intact.
- Keep heavy loads low
Hang buckets and heavy wet items on the floor and use the rack for handles and light tools.
Characteristics
Reviews
Questions and answers
Peel the pad slowly from one edge, and warm it lightly if it resists. Pulling it straight off is the one move that can lift paint, so take your time.
The clamp is built for standard mop and broom poles, including the metal shafts shown in the product photos. Thicker poles need a firmer press to seat the handle. Measure your pole before you buy if it is unusually wide.
The rack is made for mop and broom handles plus a light side-hook item. Keep heavy wet buckets on the floor, because the pad and clip are not meant to carry a full bucket.
It works on any clean, dry, smooth wall surface. Wipe the spot first, then press the pad firmly. Textured or dusty surfaces grip less well.
Yes. The side hook holds a brush, a dustpan or another light item next to the main tool, so the whole cleaning kit sits in one spot. It is not built for heavy loads.
A single clip costs less than a drilled hook you cannot patch when the lease ends, and it moves with you to the next place. Compared with a freestanding floor holder, it also returns the floor space you lose to a tool that falls over.