Touchless Foam Soap Dispenser with Automatic Sensor

Three things that make the difference at the sink

• Touch-free sensing

  The infrared sensor triggers when a hand sits 10-60mm below the nozzle. No pump to press, so nothing shared gets touched after you wash.

• Foam in 0.25 seconds

  Packaging states a 0.25s foam cycle. The wash starts the moment your hand arrives, and foam goes further than liquid, so less soap is wasted.

• Nozzle aimed at the palm

  The 25° elevated nozzle keeps foam from sticking to the wall behind the sink and makes it easy to catch in your hand.

The figures on the box

• 0.25sFoam dispensing time
• 320mlReservoir capacity
• 400 usesPackaging estimate per fill
• IPX3Water resistance rating

Hand under the nozzle, that is the whole routine

1. 1
   Load the batteries

   Open the back panel and insert 4 AA batteries (not included).

2. 2
   Fill the reservoir

   Add foaming hand soap, diluted as its label directs.

3. 3
   Place your hand

   Hold your palm 10-60mm under the nozzle.

4. 4
   Wash and rinse

   Foam appears automatically. Rub, rinse and dry.

From sticky pump to one motion

The pump you keep touching

You wash your hands, then press the same pump everyone else pressed. The handle is sticky, the counter has a crust of dried soap, and the bottle runs dry before it is half used.

One motion, clean foam

Hold your palm 10-60mm under the nozzle. The infrared sensor fires and foam is in your hand in 0.25 seconds. Nothing to press, nothing to wipe.

Your counter stays dry

The 25° nozzle aims foam into your palm, not at the wall. The clear 320ml reservoir shows the soap level, so you refill on your schedule. Packaging estimates about 400 uses per fill.