Suction Wall Soap Box with Drainage Ridges, No Drilling
A soap bar that dries on the wall, mounted with a clear suction pad and no drill. Drainage ridges lift the bar off standing water, so it drains between showers instead of going soft on the tub edge. Matte two-tone colour keeps the wall tidy.
Read the full descriptionDescription
A soap bar that dries on the wall, mounted with a clear suction pad and no drill. Drainage ridges lift the bar off standing water, so it drains between showers instead of going soft on the tub edge. Matte two-tone colour keeps the wall tidy.
Traceless wall-mounted soap box that keeps soap dry with drainage ridges and no drilling
- soggy soap sitting in water
- soap sticking to surfaces
- drilling holes or messy installation
- clutter on sink or tub edge
Soap that stays dry, with nothing drilled into your wall
Soggy bars sitting in a puddle on the tub edge become firm, drained soap on a clean wall. Stick it on with suction and skip the drill entirely.
Ridges lift the bar so water has somewhere to go
Ridges that lift the bar
Raised ridges run across the base and hold each bar a few millimetres above the floor of the tray. Water runs off to the sides instead of pooling under the soap, so the bottom of the bar stays firm longer.
Stick on, not drill in
A clear suction pad holds the box to smooth tile with no screws, anchors or tools. Your rental deposit stays intact, and there are no holes to patch when you move out.
Double-layer, wave-shaped rim
The two tiers separate the bar from the runoff, and the wave-shaped rim gives the box a soft, sculpted edge. The matte finish reads calm on white tile and does not show water spots.
Mounted in under a minute, no drill required
- 1Clean the tile
Wipe the spot with a dry cloth and remove any soap film. Suction needs a clean, smooth surface.
- 2Press the suction pad
Hold the box against the wall and press the clear pad flat with your palm. Hold it for a few seconds so the seal takes.
- 3Check the seal
Give the box a gentle tug. It should sit flat and stay put before you load it.
- 4Rest the bar on the ridges
Set the soap on the ridges, not the base, so the water drains off between uses.
Care
- Rinse after each shower
Clear soap residue from the ridges with running water.
- Wipe the matte surface
A soft sponge and mild soap keep the finish clean without shine loss.
- Dry the suction pad
Wipe the pad and the tile before reseating the box if it starts to slide.
Characteristics
Reviews
Questions and answers
Not reliably. The pad needs a smooth, flat surface. Pick a tile section away from grout lines and textured finishes, and it will hold the box steady.
Yes. It mounts on any smooth tiled or painted wall that stays dry between uses. Keep it above the water line on a tub wall so the suction stays clean.
A flat dish holds water under the bar, so soap goes soft within days. This box lifts the bar and drains it, so a single bar lasts noticeably longer between showers. It is made from solid matte plastic, and it is built to stay on the wall for years with simple rinsing.
Peel the edge of the suction pad slowly and it lifts off. Clean the tile afterward and the wall returns to how it looked before. Nothing is drilled, so there are no holes to fill.
It is a compact box built for a standard soap bar. Check the tray against your bar before you buy, since oversized or bulky bars need a careful fit.
Similar products
See all
Suction Wall Soap Box with Drainage Ridges, No Drilling