Sponge Holder with Suction Cup for Kitchen Sink
A sponge that sits in water turns sour and grey within days. This holder lifts the sponge and soap clear of the puddle, so the sink edge stays clear and both dry between uses. Suction mounts it in seconds with no drill, which suits a rental sink or a crowded bathroom counter.
Read the full descriptionDescription
A sponge that sits in water turns sour and grey within days. This holder lifts the sponge and soap clear of the puddle, so the sink edge stays clear and both dry between uses. Suction mounts it in seconds with no drill, which suits a rental sink or a crowded bathroom counter.
Suction-mounted sponge holder that keeps sponges and soap off the sink so they dry faster
- soggy sponges sitting in standing water
- cluttered sink edges and bathroom shelves
- damp soap bars sliding around
- no-drill mounting for renters
Sponges that dry instead of sitting in puddles
Your sponge goes from soggy and sour on the sink edge to lifted, draining and ready for the next wipe. Suction mounts it in seconds, no tools or holes.
Lifted out of the puddle, draining as it sits

Lifted out of standing water
The open U-shaped pocket holds the sponge above the sink floor, and water runs off through the daisy cut-outs. A sponge that dries between uses stays fresher, and you stop finding it sitting in a grey puddle every morning.

Mounts with suction, not screws
The 4.5 cm suction cup grips clean, smooth tile or glass. No drill and no holes, so it stays on a rental wall and comes off without leaving marks. Press the feet flat, wait a moment, and it is ready to load.

A keyhole slot for a second option
A keyhole-style slot on the side lets you hang the holder from a hook when the sink edge is taken by a faucet or the tile is too textured for suction.
Stick it on in under a minute
- 1Wipe the spot dry
Choose a flat patch of glazed tile, glass or stainless steel near the sink. Dry it fully, because water or dust breaks the seal.
- 2Press the suction feet
Set the holder against the surface and press each clear suction foot flat with your thumb. Hold for a few seconds.
- 3Wait, then load
Give the grip a moment before you add anything. Place one rinsed sponge or one small soap bar in the open pocket and let it drain.
Compact enough for a narrow sink edge
- 11 x 3.7 x 6.5 cmOverall size
- 4.5 cmSuction diameter
- Suction cup, no tools or screwsMounting
Sits in the corner of a narrow sink edge or bathroom counter without crowding the faucet
Characteristics
Reviews
Questions and answers
Suction works best on glazed tile, glass or stainless steel. Grout lines and textured tile break the seal, so mount the holder on a flat patch between joints. Wipe the spot dry first and press the feet flat for a few seconds.
The holder is a matte plastic with a light, budget-friendly feel. It is not heavy-duty hardware, and it is built for a sponge and a bar of soap rather than a full sink caddy. Rinse it weekly and keep it out of very hot water to slow wear.
It measures 11 x 3.7 x 6.5 cm with a 4.5 cm suction diameter. That footprint fits beside a faucet or in a corner of a narrow bathroom counter without crowding the space.
A flat tray collects water under the sponge, so the sponge sits wet and sours faster. This holder lifts the sponge clear so it dries between uses. If you replace sponges often because they go grey and smelly, keeping the one you have dry is the cheaper fix.
Yes. The open pocket holds a bar of soap the same way, and the cut-outs let water drain so the bar stops sliding in a puddle. Keep the load light, with one sponge and one small bar.
Similar products
See all







