Punch-Free Bathroom Slipper Rack That Keeps Floors Dry

A small rail that frees up your floor

• Punch-free wall mount

  The clear adhesive pad on the back of the mount grips clean tile or painted wall, so there is no drill, no dust and no plugs. Wipe the spot, press the mount flat for a few seconds, and the rail is ready to hold a pair.

• Curved rail with rounded ends

  The rail curves up at both ends, so a pair of slippers sits in place instead of sliding off. Thicker closed-toe slippers hang on it too, although it is sized for one pair at a time.

• Soft pastel finish

  The matte plastic comes in white, soft pink, lilac, mint teal and baby blue. The colours sit against bathroom tile without looking like hardware, so the rail reads as part of the room.

Mount it in three steps

1. 1
   Pick the spot

   Choose a wall beside the toilet or shower at slipper height, a little to the side of the shower spout so it stays out of direct steam.

2. 2
   Clean and dry the surface

   Wipe the tile with a dry cloth and let it dry completely. Dust, grease or moisture will weaken the adhesive grip.

3. 3
   Press and load

   Peel the protective film from the clear pad, press the mount firmly for a few seconds, then slide one pair of slippers onto the curved rail.

Easy cleaning, steady hold

• Wipe with a damp cloth

  Clean the rail as needed, then dry it with a towel.

• Keep the pad dry

  Moisture and dust are what loosen adhesive over time.

• Stay out of direct steam

  Mount the rail a little to the side of a hot shower spout.

• Re-press a lifting edge

  If an edge lifts, clean the spot and press the mount flat again.