Over-Door RV Shoe Organizer, No-Drill Adhesive Storage
Shoes and folded clothes get a clear home, and the floor of your motorhome or narrow wardrobe stays open. The matte black organizer mounts on a smooth surface with stick-on adhesive, so there is nothing to drill. Load it after the 12-hour cure and it holds shoes in deep pockets with clothes on top.
Read the full descriptionDescription
Shoes and folded clothes get a clear home, and the floor of your motorhome or narrow wardrobe stays open. The matte black organizer mounts on a smooth surface with stick-on adhesive, so there is nothing to drill. Load it after the 12-hour cure and it holds shoes in deep pockets with clothes on top.
No-drill adhesive storage that holds shoes and folded clothes in tight RV spaces
- limited storage in motorhomes and narrow wardrobes
- shoes piling up on the floor
- no place to store small items near the door
- drilling holes is not possible in rented or small vehicles
Get shoes off the floor without drilling a single hole
Your motorhome floor is buried in shoes and the wardrobe never closes right. This matte black organizer sticks to the door and gives every pair and folded shirt its own place.
Deep Pockets Where Your Floor Used to Be
- Deep pockets hold shoes off the floor
The front pockets are deep enough to keep shoes upright and out of the walkway. The upper compartment takes folded clothes, so a pile of tops no longer sits on the bench or the floor. Side mesh pockets pick up socks, chargers and small travel items that would otherwise get lost in the bottom of a locker.
- Adhesive mounting, no drill needed
Three preset points on the top edge and a removable hook keep the setup simple. Clean the surface, press the tape on by hand, and you have a mounted organizer with no screws, no holes and no visible hardware. It is ready to load after 12 hours.
Three Numbers Before You Mount It
- 12 hoursAdhesive set before you load it
- 3Pre-set points along the top edge
- 1Organizer, plus one adhesive hook
Mounted in Minutes, Ready in 12 Hours
- 1Clean the surface
Wipe the door or wardrobe panel and let it dry fully. Dust and grease are the most common reason adhesive lets go.
- 2Attach the hook
Push the removable adhesive hook into the back of the organizer until it sits firmly.
- 3Peel the film
Remove the protective film from the adhesive tape, keeping your fingers off the sticky side.
- 4Confirm the position
Hold the organizer where you want it and check the height and clearance before you commit.
- 5Press the base by hand
Press the base of the tape firmly by hand so the bond spreads evenly across the surface.
- 6Wait 12 hours
Leave the organizer untouched for 12 hours. Then load your shoes and folded clothes.
One Organizer, One Adhesive Hook
- Over-door wall storage organizer×1
Matte black fabric with deep front pockets, upper compartment and side mesh pockets
- Adhesive mounting hook×1
Removable hook that clips into the back of the organizer
Characteristics
Reviews
Questions and answers
Clean the surface, press the tape firmly, and let it cure for 12 hours before loading. The hook is removable, and the tape is made for smooth, clean panels. Test a small hidden spot first if the paint is fresh or the finish is soft.
The packaging does not list a weight limit. Shoes, boots and folded clothes are the intended load. Keep the heaviest pairs in the lower front pockets so the weight sits close to the door.
The organizer hangs from the top edge through a removable adhesive hook, so it works on flat door panels and wardrobe doors. Measure the clear space in front of the surface before you mount it, especially if the door swings into a tight aisle.
No. The adhesive needs a smooth, clean, dry surface to bond. On rough or textured panels the tape cannot grip evenly, so choose a flat door or wardrobe panel instead.
A freestanding rack takes walking space in an aisle that is already tight. This one mounts on the door, so the floor stays clear and one organizer covers shoes, folded clothes and small items for the same spot.
Similar products
See all