Insta360 X4 Silicone Lens Cover, Scratch & Drop Guard
Your X4 spends its life bumping against bike frames, pockets and pack straps. This matte black silicone cover keeps the domed lens clean and the body cushioned, so your footage stays sharp and the camera stays in the shot.
Read the full descriptionDescription
Your X4 spends its life bumping against bike frames, pockets and pack straps. This matte black silicone cover keeps the domed lens clean and the body cushioned, so your footage stays sharp and the camera stays in the shot.
Protects your Insta360 X4 lenses from scratches and drops with a snug, soft-silicone cover
- scratched lenses
- drops and impacts on action camera
- dust and debris on lens
- bulky protection that hides the camera
Shoot wild without fearing the next drop
Your X4 gets bumped on every trail, ride and pocket carry. This snug silicone cover keeps the lens scratch-free so the footage you shoot still looks like new.
Soft silicone that guards the lens
- Domed lens window
The raised silicone window sits over the lens face and blocks dust and scratches from the outside. The status LED stays visible, so you can check recording without taking the cover off.
- Rounded flexible body
Every edge of the body is rounded and soft. A knock against a rock or a railing lands on silicone instead of bare plastic corners, which is where most camera damage starts.
- Side ports stay open
A side cutout lines up with the camera ports, so you can reach them without lifting the cover off. Nothing has to be removed to get to the controls you use most.
Fit it right the first time
- 1Find the FRONT mark
The embossed FRONT marking on the cover shows which way it sits. Match it to the front of the camera before you press.
- 2Line up the side cutout
The cutout sits over the side ports. Check that the ports are clear and aligned before you seat the cover.
- 3Press it on evenly
Press the cover evenly over the body until the edges sit flush and the lens window is centred over the lens.
Small enough to carry everywhere
- 5.5 cmWidth
- 5.5 cmHeight
- Insta360 X4 bodyFits
Compact square footprint that stays out of the way on a helmet or pack
Characteristics
Reviews
Questions and answers
It guards against scratches, dust and the smaller knocks you get on a trail or in a pocket. The soft rounded body absorbs impacts that would land on bare plastic corners. It does not make the X4 crash-proof, so a hard fall onto rock can still cause damage.
Yes. The side cutout lines up with the camera ports and the status LED stays visible. For anything beyond that, lift the cover off and seat it again. It takes seconds and needs no tools.
No. At 5.5 x 5.5 cm it is compact and square, so it rides in a jacket pocket or a daypack without adding much weight or size. It protects the lens without the bulk of a full cage.
It is molded for the Insta360 X4 body. The embossed FRONT marking shows the correct orientation, so you line it up once and press it on. It is made for the X4, so check your model before you order.
A loose sleeve slides off and leaves the lens exposed, while this cover is molded to one body and stays where it is put. A lens repair or replacement costs far more than the cover, and the cover is a one-time purchase that protects the camera for every ride and trip after.
Similar products
See all




