Hole-Free Washbasin Rack for Wall-Mounted Bathroom Storage

Hook it on, not into the wall

• Hole-free adhesive mount

  Each backing plate carries a clear adhesive pad, and the rack hangs from it. There are no screws, no plugs and no drill bit anywhere near the tile. Clean the wall, press the plate firmly for about 30 seconds, and the rack is ready. When you move out, peel the plate back slowly at one corner.

• U-hooks that grip the rim

  The wire hooks are U-shaped, so the rim of a plastic basin drops into the curve and stays put. The basin hangs off the floor instead of sliding around on the tile. Standard basins sit firmly; very small ones can sit a little loose, so check the fit before you load it.

• Pastel animal plates

  Giraffe, alpaca and bear backing plates bring the colour that kids notice first. The coated wire comes in soft pink, mint teal, powder blue-grey, peach beige and sage green, so the rack suits a nursery-style bathroom as easily as a plain rental.

Three steps from box to wall

1. 1
   Clean the wall

   Wipe the spot with rubbing alcohol and let it dry fully. Dust, grease or fresh paint weakens the bond, so skip any surface that is still damp or chalky.

2. 2
   Press the backing plate

   Peel the film from the clear adhesive pad and press the animal plate flat against the wall. Hold firm pressure for about 30 seconds, then leave it alone while the adhesive settles.

3. 3
   Hang the basin

   Slide the U-shaped hook onto the rack, then set the basin rim into the curve. Spread heavier basins across both racks so no single plate carries the full load.

Two racks, two plates, one clear floor

• Wall-mounted wire basin rack×2

  Coated pastel metal with U-shaped hooks for basin rims

• Adhesive backing plate×2

  Cartoon animal shapes with a clear adhesive pad on the back

• Built-in U-hook

  Part of each rack, sized to grip a plastic basin rim