Grout and Caulk Mold Remover Gel, Whitens in 4-8 Hours
Dark grout and caulk lines turn bright white again while you go about your day. The squeeze bottle puts the gel into narrow seams where scrubbing a whole tile face wastes time. Press it on, wait, and rinse.
Read the full descriptionDescription
Dark grout and caulk lines turn bright white again while you go about your day. The squeeze bottle puts the gel into narrow seams where scrubbing a whole tile face wastes time. Press it on, wait, and rinse.
Removes stubborn mold from grout and caulk gaps, visibly whitening lines in 4-8 hours
- black mold in tile grout
- dirty mildew in caulk seams
- stains that resist scrubbing
- hard-to-reach narrow joints
Dark grout lines, bright white again by tonight
Tired of scrubbing grey-black seams that never fully clean? Press the gel into the line, wait 4-8 hours, rinse, and watch the grout come back to life.
Built for the seam, not the whole tile
Precision in narrow seams
The tapered white nozzle is narrow enough to follow a grout line or a caulk seam without painting the tile around it. Squeeze, and the gel lands on the dark line. It stays where you put it, so one pass along the joint is usually enough.

Stays put for 5 hours
Press a 3mm layer onto the dry seam and leave it alone. The directions call for a 5-hour wait, then a rinse with water. The packaging states stubborn lines whiten within 4-8 hours, and the before and after tiles show grout that has lightened after treatment.

Grout, tile, wood and plastic
The label lists walls, tiles, wood, metal and plastic, so one tube can handle the shower corner, the kitchen backsplash and a window seal. Test a hidden spot first on any finish you are unsure about.
Dry, Squeeze, Wait, Rinse
- 1Dry the seam first
Dry the grout or caulk line with a towel. Gel on a wet surface gets diluted and does less work on the mildew.
- 2Squeeze a 3mm layer
Unscrew the cap, open the nozzle, and press about 3mm of gel along the dark line. Keep the tip in the seam so the gel stays where the mildew is.
- 3Wait 5 hours
Leave the gel alone for the recommended 5 hours. The packaging says stubborn lines can visibly whiten within 4-8 hours, so give the darkest spots the full time.
- 4Rinse with water
Rinse the treated area with water and check the seams in good light. For the darkest corners, repeat the same steps on that section.
Characteristics
Reviews
Questions and answers
It is made for the dark mildew sitting inside the seam, which is where a spray never reaches. Apply a 3mm layer, wait the full 5 hours, then rinse. Heavily set mildew can need a second round on the darkest spots.
The label lists walls, tiles, wood, metal and plastic as suitable surfaces. Still, test a hidden corner first on any finish you are unsure about, then judge the result after rinsing.
A 150g tube is sized for seams, not whole walls. It covers the grout and caulk lines in a typical shower or a kitchen backsplash, and the 3mm layer is the amount you press onto each dark line.
Bleach sprays clean the surface and often leave the seam dark, so you end up scrubbing again. This gel stays in the joint and works for hours without your help, which is the time you would otherwise spend on your knees.
Expect a noticeable scent when you first open the bottle and apply it. Open a window or run the bathroom fan while the gel sits.
Similar products
See all







