Drill-Free Wall Hook Rack for Bathroom Basins & Bowls
Wet basins and sponges stop crowding the sink edge. This hook lifts them onto the wall above the basin or tub, where they drain and dry while the counter stays clear. It is built for tiled bathrooms and kitchens where drilling is not an option.
Read the full descriptionDescription
Wet basins and sponges stop crowding the sink edge. This hook lifts them onto the wall above the basin or tub, where they drain and dry while the counter stays clear. It is built for tiled bathrooms and kitchens where drilling is not an option.
Drill-free wall hook that holds washbasins and bowls neatly on the wall
- basins cluttering the bathroom floor or sink
- wet basins not drying
- damaging tiles by drilling
- limited wall space for hanging items
Hang wet basins on the wall, not on your sink
Basins and sponges crowd the sink and floor and never dry. This hook sticks to the wall with no drilling, so they hang clear and dry above the counter.
A no-drill hook that mounts in minutes
- Stick it on, skip the drill
The brushed champagne-gold plate is the whole mount. Clean the tile, press it flat, and the hook carries a basin without a single hole in the wall. Renters keep their tile intact, and the plate sits flush against the glaze.
- Hangs basins, bowls and towels
The rounded hook sits over the rim of a basin, so a wet basin hangs and drips back into the sink instead of sitting on the edge. Bowls and hand towels hang the same way, and the larger basins in our test shots held their place on the hook.
- Soft pastels, matte finish
The wheat-style plastic has a flat matte surface in blush, cream and mint. Against white tile and chrome fittings it reads calm rather than plasticky, and it sits beside a sponge or basin without pulling attention from the room.
Stick it on, press firm, and hang
- 1Clean the tile
Wipe the spot with rubbing alcohol and let it dry fully. Dust, soap film and moisture weaken the adhesive.
- 2Peel the backing
Remove the protective film from the brushed champagne-gold plate.
- 3Press it firm
Press the plate flat onto the tile and hold for several seconds. Let it settle before you load it.
- 4Hang the basin
Slide the rounded rim hook over the edge of a light basin or bowl, or hang a sponge or towel on the hook.
Everything in the box to hang it
- Wall hook with rounded basin-rim hook×1
Matte two-tone plastic in pink or beige
- Brushed champagne-gold adhesive plate×1
Self-adhesive backing, no drill or screws needed
Characteristics
Reviews
Questions and answers
Yes, when the tile is clean and fully dry before you press the plate. Wipe the spot with rubbing alcohol, let it dry, then press firmly and wait for the adhesive to settle before hanging anything. Keep the load to light basins and towels. Heavy, overfull basins belong on the floor or a shelf.
Peel it slowly from one corner, and warm the plate with a hairdryer if it resists. Pulling it fast is what lifts paint or glaze. Peeled slowly, the plate comes away without the drilled holes a rental deposit would catch.
It works best on smooth glazed tile, because the plate needs a flat surface to grip. On heavily textured or grout-heavy tile the contact area is smaller, so choose a flat tile spot near the sink or tub and clean it well first.
The hooks have a matte wheat-style finish and a brushed champagne-gold plate, which reads as a finished piece rather than thin dollar-store plastic. It is built for light loads: basins, bowls, sponges and hand towels.
Yes. It hangs a sponge, a small bowl or a colander on the wall above a kitchen sink just as easily. The same clean-tile rule applies, and the pastel finish suits a backsplash as well as bathroom tile.
Suction cups let go on wet or textured tile, and a drilled rack costs you a tile or a deposit. This hook takes one install with no tools, and it stays where you put it until you decide to take it down. For a few minutes of prep, you get a wall spot that holds basins all day.
Similar products
See all




