Breathable Two-Tone Sport Strap for Xiaomi Mi Band 3/4/5
Swap the stock strap on your Mi Band 3, 4 or 5 and the tracker finally matches your gym kit. This two-tone silicone band uses perforated vents to keep air moving across the wrist through hard sessions. It is the fastest way to give your tracker a fresh look without buying a new one.
Read the full descriptionDescription
Swap the stock strap on your Mi Band 3, 4 or 5 and the tracker finally matches your gym kit. This two-tone silicone band uses perforated vents to keep air moving across the wrist through hard sessions. It is the fastest way to give your tracker a fresh look without buying a new one.
Breathable two-tone sport strap that refreshes your Mi Band in seconds
- Worn-out or boring stock band
- Sweaty wrist discomfort during workouts
Give your Mi Band a sporty makeover that actually breathes
Stop wrestling with a clammy, faded stock strap. Swap in a perforated two-tone band and your tracker feels fresh and matches your workout gear.
Vents that keep your wrist cooler

Perforated vents that breathe
The holes let air move across your wrist, so less sweat sits trapped under the band when you push through a run or a set. The matte silicone sits softly on skin instead of holding moisture like a solid strap. Put it on your fitness band and the difference shows on the first hard session.

Two-tone colour blocking
The accent loop and band edge pick up the tracker frame colour, so the strap looks planned rather than patched on. Seven colourways run from jet black and light grey to lime green, sky blue, red, hot pink and orange. Pick the one that matches your gym bag and wear it all week.

Steel buckle, secure fit
The brushed stainless steel buckle gives the strap a finished look and a firmer close than plastic clasps. It holds its position through runs and lifts, so you stop readjusting between sets.
Swap it in three moves
- 1Press the release pins
Use a fingernail to press the pins on each side of the tracker frame, then slide the old strap out evenly. Pulling hard can bend the pins.
- 2Thread the new strap in
Line up the connectors on the new strap with the tracker frame and push the tracker in until the connectors click into place.
- 3Set the buckle
Fasten the steel buckle so it sits firm but leaves room for wrist movement. Check the fit again after a short walk.
Rinse, dry, and it stays fresh
- Rinse after sweaty sessions
Use lukewarm water and rinse the vents so salt does not sit in the holes.
- Pat dry, then air-dry fully
A damp strap traps sweat in the vents, which leads to odour and dulls the colour over time.
- Check the pins and buckle
Look over the pins and buckle now and then for wear and keep them clean.
Characteristics
Reviews
Questions and answers
Yes. The strap is built for the Mi Band 3, 4 and 5 and nothing else. Check the model printed on the back of your tracker or in the Mi Fit app before you order.
No. Mi Band 6 and later models use a different strap design, so this one will not click into the frame.
The matte silicone is soft to the touch and the perforated vents let air move across the wrist, so less sweat sits under the band. The steel buckle gives a firmer finish than plastic clasps.
Cheap no-name bands often loosen, pinch or fade. This one has a steel buckle, perforated vents and colour blocking that matches the tracker frame. A strap costs a small fraction of a new tracker, so it is the cheapest way to change how your Mi Band looks.
Rinse it with lukewarm water, pat it dry and let it air-dry fully before you wear it again. Trapped sweat in the vents is the usual cause of odour.
Press the release pins with a fingernail, slide the old strap out, then click the new one into the frame. The whole swap takes seconds.
Similar products
See all













