Beer Snorkel Dispenser: Sip Bottled Beer Mess-Free

Steel Tube, Colour-Matched Head

• Polished steel tube

  The stainless steel runs the full length of the tube, so it feels solid in the hand and rinses clean. The bend puts the mouthpiece at a natural angle, and the tube stays put while you walk, chat or lean back on a cooler.

• Colour-matched silicone head

  The elbow head matches the colour of the tube and finishes in a hose-barb tip that sits comfortably at your lips. The colour also tells you whose snorkel is whose when the whole group reaches for a bottle.

• Sip hands-free on the sand

  Slide the tube into the neck, take a sip, and keep the bottle upright in your hand. The weighted end sits in the beer, so the tube stays in place while you move around the sand, the pool edge or the grill.

Slip In, Sip, Repeat

1. 1
   Pull the rubber cap

   The rubber cap sits on the open end of the tube. Remove it before your first use so the tube can be rinsed.

2. 2
   Rinse the steel and silicone

   Run warm water through the tube and over the silicone head. This clears any factory residue before the first drink.

3. 3
   Insert into the bottle neck

   Push the tube in with a slight twist until the head sits snugly in the neck. The weighted end drops into the beer.

4. 4
   Sip and pass it on

   Keep the bottle upright in your hand and sip. When the round is over, rinse the tube and let it dry before the next party.

Quick Rinse, Ready Next Round

• Rinse after every party

  Run warm water through the tube and over the silicone head as soon as the round is done.

• Dry before storing

  Let the steel tube air dry fully, then keep it in a dry spot so no beer residue sits inside.

• Do not leave it in a drink

  Beer left in the tube for hours can sour, so pull it out once the bottle is empty.