Automatic Electric Water Pump Dispenser for Large Bottles

One touch, one clean stream

• One touch starts the flow

  The top sensor starts water flow with a single press, so there is no handle to work and no bottle to tilt. Press once to start and again to stop when the glass is full. Keep the sensor dry for a reliable start.

• A steel spout that directs the pour

  The bent stainless steel spout aims water into a glass and keeps the stream steady. It sits over the rim of a glass or carafe, so water lands where you want it. The steel wipes clean in seconds, and the chrome ring at the base gives the body a finished look.

• Fits the bottles you already own

  The dispenser fits 5L, 11.3L and 18.9L bottles, so you keep the jug you have and skip the switch to a new supplier. Smaller bottles cost more per litre and add more lifting, so staying with the large sizes is the cheaper route.

Seat it, press once, pour

1. 1
   Seat it on the bottle

   Set the dispenser on a 5L, 11.3L or 18.9L bottle. Use a level counter so the body sits straight and the spout points over your glass.

2. 2
   Check the top

   Run a finger over the bent stainless spout and the sensor button. Wipe them dry if the surface feels wet.

3. 3
   Press once to pour

   Touch the top button and water streams from the steel spout. Press again when the glass is full.

4. 4
   Wipe it after use

   Wipe the spout after each session and run a little water through it. Dry the outside so the sensor stays responsive.