18W LED Work Light — IP67 Waterproof, 9-32V for Off-Road
Blaze Every Trail with IP67 Waterproof LED Work Lights
A compact 18W powerhouse that refuses to quit. Sealed tight against water and dust, it throws brilliant white light from 9 to 32 volts — ready for any 4WD, truck, or worksite after dark.
Three Reasons This Light Outshines the Rest
Every detail was chosen for one job: relentless illumination when conditions turn nasty.
True IP67 Waterproofing
Fully sealed against dust and temporary immersion. Drive through rain, cross creeks, or work in mud — the O-rings and gaskets keep the beam burning.
18W Flood Beam
Six tightly clustered emitters push a wide, even spill — no dark corners. The cool-white color temperature cuts through fog and dust better than halogen's yellow glow.
Fits Any Bracket
At 15 × 4 cm, this light tucks into tight bumper cutouts or rooftop racks without adding bulk. Textured polymer and stainless steel hardware shrug off vibration and rust.
Off-Roaders Weigh In
Real feedback from drivers who count on these lights after sundown.
Wired these up on my Wrangler’s bumper — the spread is insane. I can finally see the ditch lines on night trails.
Forgot to turn them off for two hours after a late-night recovery. Fired right up next day, no battery drain. Bulletproof.
Mounted a pair on my flatbed truck. Vibrations are constant, but after 6 months the beam is still tight and bright.
Used them in a monsoon to light up a campsite. Zero water inside the lens — I’m genuinely impressed.
Compact enough to hide behind the grille, and the bracket is rock solid. No more cheap yellow halogens.
The pre-wired harness made installation a snap. Only wish it came with a switch, but I hardwired to my high beams easily.
Our SAR team runs three of these on the roof basket. They’ve outlasted three sets of halogen floods.
Driving trails after dark is now actually fun. The cool white light shows every rock and root.
Solid build, no plastic feel. The rubber seal is substantial — you can see it’s not a gimmick.
Got the 2-pack to replace my bumper fogs. Lower current draw than the old halogens and twice the light.
Rode 200km of dusty corrugations — bracket didn’t budge. Beam stayed true. Beast.
Good light for the price. Might get a third for the rear of the canopy as a work light.
Wire and Mount in 3 Steps
No special tools — just a drill and a wrench.
Bolt the Bracket
Choose a flat spot on your bumper, roof rack, or chassis. Secure the stainless steel bracket with the included bolt — keep it loose enough to aim later.
Connect the Harness
Red wire to positive, black to ground. The leads reach a standard battery or auxiliary fuse block. Use a 5A fuse on 12V (or 3A on 24V) for safety.
Aim and Tighten
Turn the light on and rotate the bracket until the beam falls where you need it. Tighten the bolt — you’re done.
Quick Proof Points
Hard specs that matter when you’re buying light for the long haul.
Why This Light Beats a Halogen
Side-by-side where it matters most.
| This Work LightBEST | Cheap Halogen | |
|---|---|---|
| Brightness | ✓ Crisp white flood | ✗ Dim, yellow spot |
| Water resistance | ✓ IP67 sealed | ✗ Fails in puddles |
| Voltage range | ✓ 9-32V DC | ✗ 12V only |
| Vibration durability | ✓ Solid-state LED, no filament | ✗ Filament breaks easily |
| Power draw | 18W (low load) | 55W (high draw) |
| Lens longevity | ✓ Glass, scratch-resistant | ✗ Plastic yellows |
Everything You Get
Unbox, mount, and light up in one session.
From Blackout to Big Beam
The moment you need light most, cheap halogen lights flicker and fail. We built a light that scoffs at rain, vibration, and voltage dips — so you never lose the trail again.
Dark Trails, Weak Lights
Off-road night runs end too soon when your lights can’t cut through dust or splashing mud. Standard work lights drown in a puddle or drain the battery, leaving you vulnerable at the worst moment.
Engineered for the Rough
Six precision LEDs backed by a polished aluminum reflector and sealed behind a rubber gasket. The 18W beam stays razor-bright from 9V to 32V DC — on any truck, tractor, or 4WD — and the IP67 housing keeps water and grit out.
Light Anywhere You Roam
Mount it on your bull bar, roof rack, or the back of your trailer. The pre-wired harness and stainless steel bracket mean you’re bolted on and lighting up in minutes. Go where you want, when you want — the dark won’t stop you now.
Compact Footprint
Small enough to hide, bright enough to dominate.
About this item
Rugged LED illumination that thrives where standard lights fail. The IP67 waterproof work light delivers piercing white brightness through rain, mud, and trail dust, engineered for the toughest off-ro
IP67 waterproof sealed LED work lights deliver maximum visibility for extreme off-road and nighttime work conditions
- Poor visibility in darkness
- Water damage to standard lights
- Limited compatibility with 12V and 24V systems
- Need for multiple light fixtures
Answers Before You Buy
The questions we hear most from drivers who rely on their lights.
